Products

TMC2130 Stepper Motor Driver

INQUIRY
Description

Introduction:

 

TMC2130 V2.0 Upgrade point: The newly upgraded driver, its chip is at the bottom, which can better dissipate heat
 

TMC2130 V2.0 is a new module that is optimized and upgraded to solve the problem that older drivers cannot choose to use the SPI working mode.SPI working mode of TMC2130 2.0 can directly select driver current, driver subdivision and other parameters through firmware, which makes these parameters more accurate.Using sequexternal sequencers, it can greatly reduce the workload of the chip and effectively avoid problems such as running deviation, losting step and fault caused by the overload of the chip.

  

Note:

 

1. When selecting SPI operation mode for hardware, use soldering iron carefully to prevent scalding and handle it

After the module carefully observe whether there is residual tin residue, it must be cleaned up to prevent it

Cause the short circuit of the module to burn;

2. Pay attention to the wiring sequence and IO port when wiring, the wrong wiring will directly lead to the failure of the drive.

Carefully connect them as shown above.

3 to the motherboard plug drive, pay attention to see the direction of the drive, never plug back, prevent drive

The animal was burned;

4. Do a good job in heat dissipation (heat sink + fan) before driving to prevent driving Abnormal operation

 

Type 1:TMC2130 V2.0 DIY/TMC2208 V2.1 Driver

 

Type 2: TMC2130 V2.0 SPI Driver + 1Set Wire (Soldered resistor)

 

 

BIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer Parts 

 

 

TMC2130 V2.0 SPI Mode

BIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer Parts
TMC2130 V2.0 DIY
 

 

BIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer PartsBIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer PartsBIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer PartsBIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer Parts 
TMC2208 V2.1

 

BIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer PartsBIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer PartsBIQU BIGTREETECH New Upgrade TMC2130 V2.0 TMC2208 V2.1 Silent Stepper Motor Driver Reprap SKR V1.3 for 3D Printer Parts